It’s official 330 at the hubs @ 7600rpm!!! @ 10.4psi boost. Fully scary to watch it happen, and an incredible hard edge to the exhaust note… getting up to the rev limiter certainly could feel it in your chest.

Bob set the rev limit to 8000rpm, so it’s relatively conservative in it’s state of tune – theoretically should be able to go up to 8400rpm, but when the man is saying ‘that’s good enough right there’ I’ll take the years of experience.


This post was automatically generated by GlobalWorkshop and is a part of Fraser SP330’s online documentation

Leave a Reply

Your email address will not be published. Required fields are marked *